RC10Talk - The Net's Largest Vintage R/C Community

gomachv wrote:The issue in the old trans was with a misalignment, that may be fixed now.

Cool, I should thank you guy's too, I was going to tear the transmission apart to fix the wobble but if it is normal, you saved me some work...

I went ahead and corrected the front lower shock mounting via pivot ball/lower shock pin (step 6) has the wrong picture.

Here is what the correct mounting looks like. Man if we did not have all these Re-Re builds going on here now, I would be building this thing incorrectly.



and what full compression looks like now...

SFC K wrote:

gomachv wrote:The issue in the old trans was with a misalignment, that may be fixed now.

Cool, I should thank you guy's too, I was going to tear the transmission apart to fix the wobble but if it is normal, you saved me some work...

Well...looks like they didn't fix the case as long as it spins well you are fine tho

Mine did not look like that.

Edit: Maybe when you mount it to the chassis it will close the gap. Mine looks fine...

It closes up a tad but this was the same thing on the old trannies, it's more about the alignment of the outdrives and the outdrive bearings than anything else. If it spins, your ok

Glad I could help Jeff

SnoopMaxx wrote:Glad I could help Jeff

Thank you! This is why we are here so we can help each other out.