Page 2 of 2
Re: Modernizing the RC10 hubs with SC10, B4, and other parts
Posted: Tue Jul 15, 2014 11:02 am
by RC10th
I took the complete rear drive shaft out of my B44 to test fit before I bought a new set for my OIN, and although while they "work", I only got about half the up travel before the bone would bottom out in the outdrive. I wonder if it's something to do with 1.5* vs. 3* mounts.
This was my solution to the problem
http://www.rc10talk.com/viewtopic.php?f=35&t=34582&start=45
Re: Modernizing the RC10 hubs with SC10, B4, and other parts
Posted: Tue Jul 15, 2014 12:21 pm
by Mark Westerfield
Re: Modernizing the RC10 hubs with SC10, B4, and other parts
Posted: Tue Jul 15, 2014 8:41 pm
by shoman24v
Is this used with the existing CVA on the worlds re-release? Does this eliminate the problems with clearance?
And BTW great thread above, where did you get the washers for all the flat screws?
Re: Modernizing the RC10 hubs with SC10, B4, and other parts
Posted: Tue Jul 15, 2014 11:38 pm
by RC10th
BJ4 bone with CVD axle would be the best option as pro drivers say the CVA's bind up.
The washers used on mine? They are Associated #89229.
Re: Modernizing the RC10 hubs with SC10, B4, and other parts
Posted: Tue Aug 05, 2014 4:11 pm
by covell2
Sorry did not see this thread till just now. You guys nailed the parts list sorry if I was not clear. Did not spend too much on this conversion, I'm too cheap, just raided parts off of my b4.1 and bought the sc10.2 hexes and axles from my father in law.