Page 2 of 2
Re: Andy's bulkhead
Posted: Fri Oct 19, 2007 4:20 pm
by Tadracket
tomstacey wrote:....Why not use French words?....
I tried learning French but surrendered. BWAHAHAHAHAHA!!!!
Just kidding guys.
France is the cradle of cool trends...
So what was special about BK's car, other than he was driving it? Has anyone here done a Kinwald Replica?
Re: Andy's bulkhead
Posted: Fri Oct 19, 2007 5:39 pm
by scr8p
shodog wrote:Did RPM make a narrow front arm mount? and if they did was it like the 10T which allows you to bolt the top deck of a Composit craft chassis?
rpm in the front, 10t in the back. notice the rpm has no provisions for the nose brace tubes.
not the best pic. my camera dosen't feel like working right today.
Re: Andy's bulkhead
Posted: Fri Oct 19, 2007 6:44 pm
by templeofspeed
Merde... sorry, I meant
pot-pourri...
The Associated World's Car adopted the three piece front wheels from Masami's and Matt Francis' cars... I still don't know why the Pro-Line Wide Five front tires weren't supplied...
And why AE didn't supply Losi 10-32 front stub axles like on Kinwald's car.
Re: Andy's bulkhead
Posted: Sat Oct 20, 2007 4:22 am
by Asso_man!
and from what I read in the Scan section, the front RPM bulkhead was a hop-up even if you bought the complete RPM Ultra Molded Chassis kit, correct?
Re: Andy's bulkhead
Posted: Sat Oct 20, 2007 8:16 am
by scr8p
Asso_man! wrote:and from what I read in the Scan section, the front RPM bulkhead was a hop-up even if you bought the complete RPM Ultra Molded Chassis kit, correct?
if you got the #8080 ultra molded kit (entire kit w/ arms) like i was lucky enough to get, it came with. the #8085 ultra molded kit (chassis only) did not. it was geared towards people that already had the front and rear worlds conversion kits on a rc10 tub, and wanted to upgrade to the ultra molded chassis. the #8085 kit even came with a drill template to drill the 2 holes needed in the front shock tower to attach the front chassis brace. if you notice on a 7077 worlds conversion setup, those holes aren't in the tower. unless the later 7077 kits did.
the #8090 ultra molded truck kit should have come with the rpm front bulkhead, too. but i don't believe it came with the #8095 chassis only truck kit. not positive on the truck kits, though.
Re: Andy's bulkhead
Posted: Sat Oct 20, 2007 12:19 pm
by scr8p
just to add to my previous post........................