RC10Talk - The Net's Largest Vintage R/C Community

IF my memory is correct, the Nitro DS is shorter than the GT chassis.... Found that out when I was going to convert my DS to a GT....

Blue chassie pan on the way with up grades , will post updates as I build her

This is the roller I pick up here it is with stock part cleaned off and SH.18 test fitted ,up grade's should be here in the next two weeks

I got the RX and RX box as well as my Futaba FP-s148 servo's from 1989 installed

I spy a RR steel spur on your tranny. Love those gears but wished they would have given more of a selection.

Lookin good so far...

Todd

klavy69 wrote:I spy a RR steel spur on your tranny. Love those gears but wished they would have given more of a selection.

Lookin good so far...

Todd

LOL , had to make sure it fit ok , not going on for a while I have RR inner gears and Aluminum gear case on the way , my buddy talked me into getting some more up grades , how do you say no to up grades

rebuild wrote:

klavy69 wrote:I spy a RR steel spur on your tranny. Love those gears but wished they would have given more of a selection.

Lookin good so far...

Todd

LOL , had to make sure it fit ok , not going on for a while I have RR inner gears and Aluminum gear case on the way , my buddy talked me into getting some more up grades , how do you say no to up grades

You'll get more cool RR flag decals too.

That's true can never have to many RR and RPM decals

Does any one no of a 34mm to 36 mm wide wheels that will work on the GT

Got the THS pipe mounted , raised a little hell with my pull strat but it will work onto I can get a rotor start plate