ID these rear arms, carriers from RPM

Post by **teshreve** » Thu Oct 31, 2024 7:14 pm

Losi JRX Pro-SE?
If so, they would only work using the rear holes on the chassis (lengthening the wheelbase) as the lower shock mounts are very forward.

Post by **teshreve** » Thu Oct 31, 2024 7:21 pm

I guess I should only have made 1 thread. I'll add anything else here

How about some help with these shock towers. Don't fit anything I have (I think)

Post by **jwscab** » Thu Oct 31, 2024 7:25 pm

Check the arms for marking, they may say 'rpm truck' on them. If so they are truck arms for losi

Post by **teshreve** » Thu Oct 31, 2024 7:49 pm

No markings other than RPM.
I just put them on a Pro-SE and they are are a perfect fit for inner hinge pin, length, and shock mount position in 2 axis. And it sure looks like they would mount the shock in the remaining axis if I installed the spacer (that I don't have) between the tranny and the shock tower and ran the long wheelbase setup.
I might have answered my own question

Post by **jwscab** » Thu Oct 31, 2024 8:05 pm

Yes that is what they are then. You need the shock tower spacer I believe.

Post by **BattleTrak** » Thu Oct 31, 2024 10:29 pm

Arms are #7345 Jrx2 rear arm conversion kit.

RC10Talk - The Net's Largest Vintage R/C Community

ID these rear arms, carriers from RPM

ID these rear arms, carriers from RPM

Re: ID these rear arms, carriers from RPM

Re: ID these rear arms, carriers from RPM

Re: ID these rear arms, carriers from RPM

Re: ID these rear arms, carriers from RPM

Re: ID these rear arms, carriers from RPM

Create an account or sign in to join the discussion

Create an account

Sign in

Who is online