So what did you get in the post today ???

[Incredible_Serious]

Nice little package of Speed Passion gear arrived today.... Reventon S and Stock Club Race ESCs, 17.5R motor, as well as a USB programmer and instructions. Got these for a good price, too

Alex

[threesheds]

Drive cups
4PCS Steel Joint Cup B Set for HSP 94122 94123 94111 Redcat 1:10 RC Car
From eBay for an hirobo zerda restore and surprise surprise they fit.

[HawkeyeLTS]

A whole pile of GT parts!!

[Frankentruck]

I picked up a TERX 75AM and TSC 411P set. They came attached to a nice 12L carrying case. I'll probably look to see if someone else needs this nice 12L because I have a few of them already.
.

[morrisey0]

Got some new RC10 universals from JC Racing. It is kinda weird, as I have never actually seen universals that weren't completely worn out.

[Trass]

hi,

SG PRIMA






Jerome

[juicedcoupe]

Got some motors and motor parts. They looked better in pictures than in person, so I probably overpaid.

[Phin]

A 44B that isn't as bad as it looks.

[juicedcoupe]

Not exactly RC related but it is forum related.

I've been thinking of getting a 12" Galaxy tab for a while. They popped up on sale at Amazon, so I had to do it.

Here it is, with my old 10" Samsung and a 8" Fire tab.

[Dadio]

A 44B that isn't as bad as it looks.

pic1s.jpg

Ooh ! I see alloy arms and hub carrier , need to see more of that ,hope your doing a refurb thread

[Phin]

Ooh ! I see alloy arms and hub carrier , need to see more of that ,hope your doing a refurb thread

Unfortunately it only came with one hub.

[vintage AE]

Thanks to Frankentruck, I got some nice 3D printed white rear bulkheads for my A&L build and more. Much appreciated!

[Frankentruck]

Glad to help out and save that nice RC10 Graphite bulkhead from a double amputation.

[Frankentruck]

After seeing Amain raise the price $30 *AND* start collecting state sales tax I had a bit of a 'get off my butt and get one' moment with the Super Clodbuster. Michael's RC Hobbies has been my big purchase place a couple of times now. I immediately got some eye rolls and a slew of sighs from the wife, but the need for the SCB was too strong to be denied.

Now I need to figure out the minimum mandatory upgrades for the build. Bearings, steel pinions (Robinson 13T 0.6mod?), 1 or 2 good steering servos, some chassis trim locations for more steering capability? I'm sure it's all documented, just have to dig.
.

[MarkyDents]

Or…… also stretch it out a wee bit