First sorry for the English but I am French

This is my first thread on RC10Talk and I choosen to present you my Samurai build.
I bought 2 models plus some NIP parts as some where weared on both

Here we go :
Polishing the FWD plate



The shocks are long to polish as there are many corners

As per manual I started with FWD diff with some NIP parts




The FWD diff is NIP


Done but something is missing between FWD and rear

Previous diff is cracked near little black scerws. Do not tighten a lot.
It will stay on a shelf as it is very weak but I put a correct era option: ball bearings


FWD is done :smoke:

It is not so easy to build the FWD as there are a lot of parts going into others.
Almost finished with genuine mechanical speed controller and associated lots of wires

The two halves chassis are NIP as all were broken at shocks or rear diff attachements.

The driver:


I couldn't install the BIGGG ACOMS receiver and the driver. Maybe that's why the driver was not there when I bought the buggy.

Instead of doing 100% box art I added a touch of green.


It is was a very nice model produced by Marui. One of the most beautiful of RC in my opinion with the Scorpion and the Javelin
I hope you will like it also.
See ya...