B3 to nix9200 basher

[Waz]

Gold star to someone that notices the familiarity to another members pictures... we are related.

The beginning which started by my brother asking me if i wanted a b3 because it was cheap. So down under it came from the states

It sat as a roller for abit then a lot of buggys came up which i stole some electrics from.

[Waz]

Eventually i toasted the 8turn brushed motor. Electrics from my b5m were later swapped into the b3.

I did the b4.2 hex swap for more wheel options and also to try the wide front rubber. Pictured are some old cva b4 axles i tested, these were replaced with new mip b4 cvd axles.

[Waz]

New 17.5t combo was next on the cards so i could hand my old brushless stuff down to another buggy. Also a new cheap low profile servo went in at the same time.

[Waz]

Now the fun. I kind of miss not caring about scratching the underside of the chassis.

Nix9200+6mm chassis with lipo trays. Also got a worlds rear tower to get the body fitting correctly. An aluminum trans mount was added because i was sick of stripping carbon ones. Got some new gears (69x31) and titanium motor screws.

[RC10th]

I'd say your related to green510?

Interesting use of the truck front body mounts. Keep up the good work and looking forward to action shots.

[matt1ptkn]

Looks suspiciously like this one: http://www.rc10talk.com/viewtopic.php?f=88&t=41706. I really like simple paint schemes. Maybe because that's all I am capable of...

[Waz]

Correct. Green510!

No action pics unfortunately, tracks been rained out for weeks

[Waz]

Didnt get any decent shots.

Managed to tear off some chassis protector and scratch the chassis. Also the rear 3d printed motor protector cracked.

[Waz]

http://s1187.photobucket.com/user/works510/media/Mobile%20Uploads/received_318995298533266_zpsdziqkk5t.mp4.html

Pretty average video quality to match my driving!