Andy´s trailing arm build

[DennisM]

Thanks to Jeff for the fine chassis and rear shock mount

Are there any bodies especially for the Andy´s trailing arms?

[DennisM]

This is how it ended so far. replaced the "original" trailing arm rear suspension mount with a standard, and used some shorter shocks to keep the body low.

Please try to keep Your enthusiasm down this time - I know it´s hard, but please try and keep the comments to a minimum

[GoMachV]

Well "I" think it's cool!

Not quite A&L trailing arm cool....but cool

j/k

[DennisM]

Thanks for being supportive Jeff
As soon as I find that "New Owner" coupon code in my mail I´ll buy a set

[Mr. ED]

You need a big white wing on the rear, and paint those nose tubes white

[GoMachV]

Thanks for being supportive Jeff
As soon as I find that "New Owner" coupon code in my mail I´ll buy a set

You didn't get that yet? Ugh. I'll talk to my IT person

[klavy69]

As soon as I find that "New Owner" coupon code in my mail I´ll buy a set

and a lethal weapon and traxxas dogbone setups and and and

As far as the buggy goes in the final product why did you change out the wheels Dennis? What did you do to mount the nose tubes to the chassis? I think it looks good as is but looked great pre-body shots with just the right amount of shelfer bling

Todd

[DennisM]

As soon as I find that "New Owner" coupon code in my mail I´ll buy a set

and a lethal weapon and traxxas dogbone setups and and and

As far as the buggy goes in the final product why did you change out the wheels Dennis? What did you do to mount the nose tubes to the chassis? I think it looks good as is but looked great pre-body shots with just the right amount of shelfer bling

Todd

Well, since I had to replace the gold shocks because of the lenght of the rears, I took revenge and replaced the aluminum rims
The nose braces are bent 6mm aluminum rods.