shapeways durability?
-
Mr. ED
- Approved Member
- Posts: 5483
- Joined: Thu Dec 21, 2006 1:30 am
- Location: Back @ home: Belgium
- Has thanked: 62 times
- Been thanked: 62 times
Re: shapeways durability?
http://www.oople.com/forums/showthread.php?t=156404
Probably a good option for anyone in europe.
Paul knows the requirements of rc and is probably more willing to communicate about print orientation etc. than shapeways or materialize.
I'm actually thinking about handing over my works 91 suspension arm design to him.
Probably a good option for anyone in europe.
Paul knows the requirements of rc and is probably more willing to communicate about print orientation etc. than shapeways or materialize.
I'm actually thinking about handing over my works 91 suspension arm design to him.
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 15 Replies
- 1769 Views
-
Last post by RC Chick
-
- 1 Replies
- 865 Views
-
Last post by slow_jun
-
- 12 Replies
- 1493 Views
-
Last post by GAMMACRUSH
-
- 8 Replies
- 845 Views
-
Last post by Frankentruck
-
- 1 Replies
- 1484 Views
-
Last post by Mark Westerfield
-
- 8 Replies
- 1349 Views
-
Last post by teman
-
- 10 Replies
- 1340 Views
-
Last post by kaiser
-
- 10 Replies
- 2812 Views
-
Last post by Dadio
Who is online
Users browsing this forum: No registered users and 20 guests