On vacation with the family...wife, son, daughter, 2 brothers, their wives...
We were offered free use of a damn nice house near the beach in Fort Myers. First trip more than 50 miles from home in 4 years, we really needed that. If only it were less than 95* every day...
Got a couple of kyoshos I need help put a name to so I can sell them :oops: . Thinkin I could get some useable parts off of either of them for my laser zxr and I really liked the body on the nitro but health and time has made a decision for me to...
Last post
yeah, thats it. I need to sit down and make a hard copy of all the members I make deals with that has their name, address, user id here and ebay user id so I can remember these kind of things :wink:
So my interest in Yokomo buggies has been growing and I'm at the point where I would like to take the plunge and start a vintage restoration. I'm looking for advice on which model to get. My points of concern are:
Popularity
Available...
Last post
Well your off to a good start, found one of the rarest parts going. Nice 8)
I just converted a b3 over to mip cvd's for a b2. The axles just engage the outdrive . Do i use down stops on the shocks to correct or am i just wasting my time. My b3 had 1/4 axles and just what to update to 3/16 . The reason i did this because i...
Last post
the outer axel half is spaced differently on the b3 the shoulder to pin is different
Anyone have a good racing setup for a gold pan?
My car will have the a&l trans,wide front end with Andys front arm holder,rear b2 cvds (2.2 wheels) and stock everything else. The rear upper link has been re-drilled already to make it longer.The pack...
Last post
that' s the setup I always ran, If you run a lipo probably put 1 oz of weight somewhere under the battery.
I have a new McAllister truck body sitting on my JRXT and I am drawing a blank when it comes to paint :shock:
I need inspiration! Please post some good paint schemes up for me?
Last post
So whats going on with this truck I cant wait to see how it looks ???? I wrenched a lot on it for you so you could finish it off were are you I dont see any pictures??
thanks for accepting me in the forum. I write from Milano, Italy. I would liked to ask your help:
I bought the RC10 classic re-release. Can you please suggest me the list of components ( Motor, esc, servo, batteries) that you think that...
I was told this was a hopped up TC 3 but now that I need a new out drive on the rear diff, nothing matches. The diff ring and mating out drive have double flats. The stock parts have a single flat and the diameter is a bit smaller so the fit in the...
Last post
Thanks, looks like a pain in the tail to find parts for. From reading, the out drives were a weak link. Cant seem to find much out there part wise for them. Sounds like I will part out the chassis and she will be dead in the water till a tc3 or 4...