RC10T back from the dead!

[cautrell05]

I have a stock 3-gear Stealth trans and it was as easy as remove old top-shaft and install new top-shaft.

They looked like the GT mounts from this pic is why I was asking.

Nick

[Vermin]

Nope, those are RPM's with the third mounting hole (not sure if GT's had that) and some dremel work for dogbone clearance.

[Charlie don't surf]

Cautrell's correct, they are 3deg RPM RC10GT mounts- they are basically the same mount with a slightly different front to rear spacing. But the "third" hole is a dead giveaway- I have some white ones NIP for reference in needed

[scr8p]

the other dead giveaway they're gt mounts is the loss of wheelbase.......

[Vermin]

Ahhhhh - RPM's FOR the GT .... got it

Thanks for the schooling guys

[evownsu]

what tire/wheel combo are you running in the rear?

[Vermin]

what tire/wheel combo are you running in the rear?

HPI Mesh wheels with Pro-Line Gladiators - sorry for the delay - was on here poking around as I just had an old 6-gear RC10 given to me and I'm planning a restore, saw that I had missed a question

[mfabrizius]

i have my original rc10t im getting bacl on the track ... i have the stealth tranny what gears have you foound to work best with a brushless setup ? any help would be appeciated.