Oooohh, I remember those from way back in the day. I don't think they ever saw production. These are form the "RED" Proline days, I had a few sets for testing, shoulda been 91'-92' maybe. -Jeff
I picked up some NOS Pro-Line 2639 2.2 front wheels for the B2 and B3, but am having a problem. The inner bearing fits perfectly properly, but the outer bearing falls into the wheel and does not fit snug.
I used my caliper, and the inner bearing...
Last post
I'd be happy to trade them off for some wide 2.2 b2/b3 wheels where the bearing fits snug. Do the genuine Associated fit? are there any other options?
I have three sets. all brand new, never seen glue.
I am looking for front tires for my TRX-1 shelfer.
I do not need original tires just ones that will fit the front wheels.
Does anybody have any suggestions on where to find some? Similar to 4740
I found rear tires already.
Thanks
Last post
Those Jconcepts look good. I may have to just try them out.
Anyone know if the front tires from and Ultima would fit on the original Raider wheels? One of the front tires on the Raider I am restoring is as hard as a rock so I need to find a replacement. I have some from an old Losi Junior 2 but they are too...
Last post
I have a brand new never been run pair of those tires. They aren't in the package anymore but they were until about 4 months ago. I saw them in a hobby shop in an old discount bin and bought them solely to mount on some old wheels. They are hard as...
Where the tires that came with the 10t kits the same as the buggy front tires? Does anyone make a similiar wheel? Are the same as a current buggy wheel?
Last post
I'd give those wheels a soak and see if they were intact - a lot of folks 'flattened' them to accept foam but who knows until you have a look at the complete wheel. Acetone or lacquer thinner should take care of any glue holding the foam!
I questioned them as being from the early 7001 shipment because of the information another member posted to the RC10T history thread. Has it been confirmed that did happen ?