BEFORE:
It is mainly stock, added bearings and some Lunsford Ti.
In the transmission I replace the original black ideal gear with a new one and I replace the slipper clutch system with an SC10 new slipper (I am using the old parts for a shelf car I am planning on). I am also using B4 rear CVD axles, LC ball cups and T4 front steering block carrier assembly making the truck a bit wider than original.
That is some strong flash on the cam.
The truck was in great conditions, It has some scratches but It looks like it was ran and never really taken apart after that. I think that this helps keep the parts in better conditions for a re-built.
- The clean up
- The rebuilding of the transmission
- SC10 slipper with top shaft
- Remember to add the T2 spacers in the inside to the sc10 top shaft.
- The built up
- I cut the front nose plate and I am making a custom bumper for it
- JConcepts ball cups
- sc10 front parts
I am rebuilding the shocks; they have the older round cap seals that I am re-using on another project.
I am looking for some new white Pro-Line rear wheels and bar codes rubber and I am planning on using a T3 Pro-line crowd pleazer body, I always love that body but never got one until now.
=/
