Front sway bar parts question

[aconsola]

I've never built or de-soldered a roll bar, are the ball studs threaded inside?
Are the front sway bar parts simply re-packaged dubro parts?
If so is this the correct parts pack for the ball stud:
http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXD896&P=7

and these for a multi pack of just the ball cups:
http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXD901&P=7

I picked up a couple packs of each at the lhs. The 4pack of rod ends looks much whiter than the old AE ones I have. the single ballcup packaged with the stud is more clear/translucent like the used rollbar I am trying to replace.

Thanks!

[templeofspeed]

That's the right stuff.

The 1st part is also correct for the RC12L ride height adjuster. The tall ball stud is 4-40 thread internally. Yes, AE just repacked the DuBro stuff.

[aconsola]

Thanks for the info. One more question, what is the proper size wire for making the bar?

[templeofspeed]

Thanks for the info. One more question, what is the proper size wire for making the bar?

"wing wire" for the rear, smaller for the front...