Anyone know the dimensions of these?
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXZUD0&P=7
custom works front arms
-
THEYTOOKMYTHUMB
- Super Member
- Posts: 7072
- Joined: Wed Oct 22, 2008 5:15 pm
- Location: Evansville, IN
- Has thanked: 3438 times
- Been thanked: 1889 times
Re: custom works front arms
Can't answer your question, but just curious. What's your plans for them? I only ask because I'm not sure I've seen a worse/cheap looking mold job. That pic looks terrible at least. I would expect better quality from CW.jwscab wrote:Anyone know the dimensions of these?
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXZUD0&P=7
I don't mean any disrespect to anything you're trying, I'm just a bit put off by the terrible look of those. In college I did quite a bit of temp work in plastic factories and those look like rejects...
The may clean up with an Xacto though.
"The world looks so much better through beer goggles: Enjoy today, you never know what tomorrow may bring."
Ken
Ken
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 7 Replies
- 1968 Views
-
Last post by fredswain
-
- 5 Replies
- 1569 Views
-
Last post by Badmuthatrucker
-
- 1 Replies
- 1577 Views
-
Last post by Charlie don't surf
-
- 12 Replies
- 2122 Views
-
Last post by nikos2002
-
- 15 Replies
- 1937 Views
-
Last post by dldiaz
-
- 11 Replies
- 3621 Views
-
Last post by scr8p
-
- 0 Replies
- 980 Views
-
Last post by mytimac
-
- 1 Replies
- 1759 Views
-
Last post by Charlie don't surf
Who is online
Users browsing this forum: No registered users and 14 guests