Again a 4wd to present to you, a COYOTE SG 4wd.
Like it's a special car , I love , I make a preparation to run without troubles.
The transmission is a major problem , the original spur diff are too bad and like mine are dead, I used the spur diff from the B44 with the small pinion.
with many work, pass the spur on the lathe .
Big luke the 4 screws on the spur are on a tooth
The 4 screws are sand.
Drill the shaft , to put the axle for the pinion.
I keep the plastic ring , on the lathe I drill holes for 2 flanged ball bearing 5x10x2.5 mm.
The shocks , the original are
, 1 O ring .I made new piston with 2 small holes.
The shafts are new but look like the grand canyon,I used the shock shaft from GPX4 HOBAO or 1/10 on road, On the lathe I drill the cartbridge to put 2 O rings with a washer and glue a small lexan ring.
The caps pass on the lathe too.
I siliconed the caps on the body and put a thin O ring on the cartbridge.
Result , really good shock
I made too a new shock tower, because the original in plastic are crack and push the shock too far and twist the arm and in the same time reinforce the body post.
I put washers under balls arms to give more caster for the front and antisquat for the rear.
The suit soon...
sg were much more prominent in 1/8th weren't they!
