I'd have used triangles.
The problem is no not bending of the long beam but tording: the beam is flat and narrow.
As you push up the front left: the narrow flat a long crossing beam; from the front right to left rear will twist along its centerline.
the beginnings of weapon X-updates 2/21/2011
- jwscab
- Approved Member
- Posts: 6570
- Joined: Wed Jan 28, 2009 9:42 am
- Location: Chalfont, PA
- Has thanked: 16 times
- Been thanked: 498 times
Re: the beginnings of weapon X-updates 1/27-2011 finally!
I think the car is done for now, but I still have a few items to clean up/fabricate
countersink holes on chassis
fr/rr bumpers
couple of hinge pins
wing mounts
trim XX body
battery stays
couple of threaded standoffs to replace through hole ones
As it is, it will roll on it's own, and with electronics, completely driveable, so here are some pics!
countersink holes on chassis
fr/rr bumpers
couple of hinge pins
wing mounts
trim XX body
battery stays
couple of threaded standoffs to replace through hole ones
As it is, it will roll on it's own, and with electronics, completely driveable, so here are some pics!
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 8 Replies
- 1420 Views
-
Last post by MONSTER
-
- 116 Replies
- 34089 Views
-
Last post by mytimac
-
- 0 Replies
- 683 Views
-
Last post by RCveteran
-
- 55 Replies
- 6118 Views
-
Last post by jwscab
-
- 17 Replies
- 2483 Views
-
Last post by jimbobarooney
-
- 26 Replies
- 4216 Views
-
Last post by Jared J
-
- 9 Replies
- 1752 Views
-
Last post by Coelacanth
-
- 1 Replies
- 262 Views
-
Last post by Tang
Who is online
Users browsing this forum: No registered users and 18 guests