B4 owners...

[Jay Dub]

I am currently drawing up some RC10 rear arms for use with B4 rear hubs and CVD's. If someone can give me a measurement from center line of outside rear hinge pin to center line of outside rear hinge pin (arms level btw) on the B4 that would be awesome! (should be around 180mm?). Just tryng to avoid a bunch of trial and error Thanks -Jeff

[klavy69]

I've got 178mm on one and 179mm on another. Measured both twice and thats one I got
Hope this helped.
Todd

[Jay Dub]

Cool, thanks soo much. I take it you have 2 B4's . -Jeff

[klavy69]

Kinda got 2-1/2 ...picked up a partial roller for parts off of eau rouge awhile back at the same time as winning one off ebay for $50...one of those when it rains it pours deals
Todd

[Jay Dub]

Yeah, I seem to run into those too. First with my benchtop mills (3 at one time, after searching for years for the "right one"), and more recently with Pro Radiants . -Jeff