new guy rc10t runner

[92vert]

i recently purchased a near mint 10t roller. now equiped with a 15t blitz motor tazer 12t esc spektrum rx. got 25 mph out of 19/87 gearing would like to go brushless any recomendations or just keep brushed for reliability. will try to get pics posted

[92vert]

also what bodies fit the 10t dont want to ruin original body and anyone have a link oir ideas on gear ratios or can help fig out what i should be running have a 15t motor running 16 or 19 and 87 spur would like to run bl 13.5 or traxxas vxl ideas on gearing

[cyclepsych0]

As far as bodies go, I remove the stock 10T rear mounts from the tower and add a single buggy rear mount to the trans brace.....

http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LX2724&P=SM

Then, a stock T3 body bolts right on with no issues whatsoever...

http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LX3177&P=SM

I've done this on 3 of my runners with no issues at all. The stock 10T front body mounts are fine the way they are.. Plus, with this set-up you no longer have to worry about losing the tiny 10T stock rear body mount "nubs"....

[92vert]

thanks alot gonna have to try that only run a few times and ripped the nubs out with just a stock 15t motor took truck to my local track did ok with stock tires but new ones would be alot better

[92vert]

tried to add pic but cant get small enough

[Charlie don't surf]

1024 X 760, or PC mode in your camera--it's easy

[92vert]

went racing sat was 10 sec off the pace all the other guys had big kv bl motors picked up a traxxas vxl setup got to figure out how to mount esc and extend bat tray for lipo. ran with a 16t pin and 87 spur and just killed the slipper. put a 26 pinion on gonna try again