it's a 6900kv mamba, it can only handle the 2 cell lipos like the 7200kv but i think i might run a 8 cell pack that puts it right at 66000 rpm, which is 1000 rpm over the motors limit.
not sure yet, but i think the lipo 2 cell 20s might be better because the packs i'm runnin' now start cookin' after a few fast runs.
Another 40-something dude with a gold pan that's been sitting in a box for 20 years...
Mine's an '88, A-stamp, original narrow suspension and ball diff. A couple of years ago I got a stealth, but have not drilled my A-pan.
Wanting to go...
Last post
this is the manual i got with mine, and the only one on TA's web site that i could find. it's basically one page folded pamphlet. mentions a lot of stuff but nothing about reverse polarity protection:
I know that this subject as been beaten to death, but I was wondering if any one has use this set up or anything like it ?? Here is the link:
Thanks for the Help
Last post
that motor setup will be ok with a good 6 gear trans.... good 6gear trans = bearings (i use out drive bearings too) and try using idle gears less then 20 years old :D (new ones are like $5 and worth it) ... its like people said the 6 gear can take a...
Trinity pulse 10.5, it's close to being the same colour, haven't seen any other gold anodised motors but post them if you see any. Only the 10.5 is gold I guess so scrutineers can pick easily it for super stock.
Last post
Dayum, that's close! It still makes me chuckle to see a Trinity brushless product knowing how badly they bashed brushless technology back a few years ago :lol:.
how did they bash brushless??? i like brushless cause they run great ,but on the other...
i don't want to destroy the 6-gear tranny. are 17.5T blinky motors about right or are even they too much torque?
-peter
Last post
Chris, I already have a couple of stealth'd rc10's: a rere worlds and a classic worlds (more or less) that I built up out of parts. And I have a couple of spare stealth's lying around to boot.
The reason for the six-gear is its my original from 30...
Hello All. I've had an interest in vintage RC10s ever since I remember reading about the worlds and RC10T kits in the magazines as a kid. I figured now is a good time to get into it with the ReRes out. I just traced a TC4 for what you see in the...
Last post
I won an auction for some front end parts for the second car. Once I have them in I'll be doing a cleanup of all of the plastics.
So, this was my first rear RC, bought with a lot of hard-earned lawn mowing/snow shoveling/pet sitting money back in '94 when I was 12. I ran it until the MSC burned up, then it got shelved. I got back into RC when I was 19, but I was into nitro...
Last post
Hard on my kits sounds like an understatement.
Well, I prefer to look at it as most manufacturers just not building them tough enough :wink:
It's one reason I won't waste my time with Traxxas, though. Save for the Revo, their stuff breaks if I...
hey guys,i plan on restoring a gold tub soon and putting the brushless motor from my Firestorm in.the motor and esc are mad by castle creations for hpi.will the rc10 trans hold up to the power?its not the most powerful combo,but i would just like to...
Last post
And the 6 gear? ;)
I just got a mild brushless setup and was going to try it in my 6 gear. It has the modern black idlers and full bearings, so I was thinking it would be fine if I dialed out some of the punch.
Any thoughts on that?