RC10T Losi XXX wheel conversion....mine anyway.

Post by **Dieselpower** » Wed Jul 29, 2009 2:15 pm

Got a balck tub for VONATS and was pondering what to do about the 1/4" axles on the CVDs it came with. I had an extra set of Evader Nitro ST CVDs laying around and low and behold....the DTX axles fit perfectly into the AE/MIP bones. I opted for running the Evader rear hubs as well as they fit nice also, but the stock AE hubs can be used if you grab four 5x10x4mm bearings.

Just a heads up for anyone that might have a scrap pile not unlike my own. I'm sure there are a myriad of other options out there.

Post by **Charlie don't surf** » Wed Jul 29, 2009 2:58 pm

How bout some pics?, did the Evader hubs change any dimensions?

RC10Talk - The Net's Largest Vintage R/C Community