RC10Talk - The Net's Largest Vintage R/C Community

I know it’s for smaller wire but when I saw this clip on Facebook I immediately thought of this thread. Might be a handy idea for something in the future

That gear cover looks like a replacement for the Hirobo cars like the 44b. Scoot Mike might need that

A popular method was to run longer screws through the bellcrank and use it to mount the body, but it was usually done on just one side. This was from the Worlds car manual...

Congrats!

The only red I can get is a bit dark compared to the Hot Trick red

My understanding is that it’s larger all around. They are both 1/18 so the midget would be ballpark 3/4 of the size of a sprint

I did this video years ago to demonstrate the poor fitment of the rere case and idler. I think both are at fault, as you can see by the video. My topshaft was not a problem. Some were. The typical top shaft problem is that the slipper hub hits the motor plate. Rere stock shown first Rere idler in 65...

Associated 2293 and 3911 comes with the 3/8 shims and some 3/16 as well

I’ll throw one in This is a vintage car that never was. Daryl has produced a couple but they never went into production. This was to be a platform to sell as a usable display chassis. Very much mimicking the design of the Bolink Legends but allowing sedan tires and wheels to be used. There were a lo...

This got me digging and I found one of the USA shippers has these in bulk (2x, 4x, 5x, 10x) at a good discount. I put one of the handy two packs ($28) in my watch list for the next time there is a coupon. That will make them $12 a pop shipped.

https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F263304541322

And the handy 10 pack for $133

https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F263426854701

Updated the pics in the first post but they aren’t in any particular order

That’s a change box. Was designed to change the ratio of the stealth to a 2.61

Here are the instructions
https://www.rc10talk.com/viewtopic.php?t=2280

Lunsford has titanium wide axles in stock also, I grabbed a couple pair for my rigs. They are labeled for the gt I think

The image link you posted takes you to a gallery instead of a single pic. I’ll just post them here for everyone to make it easier.

It’s a later CE, but not very late as they went to black parts at the end.