RC10Talk - The Net's Largest Vintage R/C Community

Ok cool, it must be on my end then!

Edit, yep I had the wrong time zone- not sure how that changed as it's only recently been wrong

lower turn brushed motors as well as lower turn brushless motors are harder on speed controls- drawing more current. Thus an old brushed esc might have had a 13t motor limit- so anything higher turn is ok. A modern brushless with a 13.5t limit would be ok with anything higher. Perhaps you were think...

yep thats correct, he went with a different threading.

My X1c's are listed as "Ampak" as they run a different controller, but a quick google shows others saying the P1 will come up as expressif (as well as smart light bulbs, switches, etc using the ESP32 module)

XLR8 wrote: Any suggestions?

Yes, send me your address and I'll find a phone in my collection to send you. It's a 2 minute task once you have a proper device.

Yeah that's awesome. I didn't realize they were emailing people about it. Great customer service!

I ended up removing my design where the bearings were centered and went to a premade design where the roll was sitting on the bearings and that solved my issue. With the Bambu my filament resides either in the ams or inside a filament dryer with rollers

man... how many of you guys go search info for something you have and end up literally right back where you started to a thread you created almost 20 damn years ago... :roll: I might have you beat. I will sometimes be searching eBay and stop on an interesting item just to find out it's one of my li...

Keeps the rings from slipping on the hubs. I usually use a touch of black grease, some people would glue them.

Popped the seal on a couple Cadillac kits and figured id share the moment.

6016 kit w/ bearings


6020 kit w/ battery

badhoopty wrote: ↑Mon Nov 18, 2024 11:27 am i totally believed you got these at a goodwill...

The whole Goodwill thing has been a running joke, akin to the "two weeks" for all new AE products I just couldn't resist

for those not on facebook....

They are the saft cells, I'll snap some pics later. Here is the sticker sheet that was in the box.

I'm not sure how I feel about this :lol: I fought myself over it for sure. Since I will never sell them, it wasnt about value but I still wasnt sure. The deciding factor was the battery in the 6020, wondering if it had leaked all over the tub. Then once I did that and saw the sticker sheet that I d...

Built up an old chassis I had kicking around, this tub is twisted and bent, and a few holes drilled out for some reason. I left it with the powder coater a while back and said to surprise me. I dig the orange! I installed the Ten4.1 kit, short arm version Also has the irs-10 trailing arm set which w...

They were a limited run item, and due to the time it took to break in and Dyno each of them I just don't know if I will do another batch.

If you make a purchase from us and would like a label I would be happy to send one so you can sticker up your own motor