RC10Talk - The Net's Largest Vintage R/C Community

Well, raced it this weekend. And yes, I changed shocks again.

Nostalgic RC

Scammers are losing business with all the the vintage re-releases. I really hate to see it happen to such wonderful humans.

Not sure if you are racing/bashing or what 17.5 motor, but my race setup yields 75/28-29 with a FDR around 5.0 for 17.5 Blinky with a Reedy SP5 with a 30mm motor fan, so with your 84 and racing you could look at 84/26-28 conservatively for racing to 84/21-23 for messing around I would think. * the 7...

I'd go for a 6 pack of steel pinions

http://www.robinsonracing.com/catalog/one_eight_inch_bore_pinions.html

Place holder

Ofna Ultra MBX.

Allow me to present my PB Mini Mustang, as raced in the recently-completed Vintage Bash V3 down here at the Knox offroad track, Melbourne Australia. No shelf queen here! MIniMustang.jpg Has installed a silver can motor as per the class rules, matched to a Hobbywing 1060 ESC. Radio gear is basic FlyS...

It may look like a RC10 but it's actually a 1/24 scale NRC-24 nrc24.jpg nrc24-2.jpg Build Thread: https://www.rc10talk.com/viewtopic.php?t=48693 I modified this one to use Proline oil filled shocks and made some 5 spoke wheels to match most of my 1/10 fleet. Really fun little build, some video of me...

My Kyosho Javelin

https://youtu.be/5SlgAwCd76E?si=QJxm6GbA59Azs8UJ

I need a cvd set for and rc10 vintage build. I tried using the MIP cvd set and while it's a quality item, it is either too sort or I need to limit my shock travel length. I'm using the 3/16" axles and need a longer dog bone/center shaft. JC Racing has a +2 but there's got to be an alternative ...

I use that Custom Works Short kit (CSW7210) and with the shims it has, I get good outdrive engagement. It is an MIP CVD kit that has been repackaged as Custom Works. For your MIP CVD setup, where are the shims? Are they all on the wheel side of the axle? Maybe some they need to be moved to push the ...

I use that Custom Works Short kit (CSW7210) and with the shims it has, I get good outdrive engagement. It is an MIP CVD kit that has been repackaged as Custom Works. For your MIP CVD setup, where are the shims? Are they all on the wheel side of the axle? Maybe some they need to be moved to push the...

the width related to between the bearings and its only a couple shims worth. AE rere CVA's were notoriously short, I hope MIP didnt just copy those

IMG_9373.jpeg IMG_9366.jpeg Jay Halsey tribute kit AYK 240r motor Titan Pro-x esc Full sealed bearing kit (sans front wheels, the black tribute wheels use a bigger 3/8 OD bearing, which neither Myself nor the vender new, so those are in route) Modern receiver and Savox servo to be able to run it sa...

I’m going to lose my mind. I was able to get into the box and check things out. I got to the sticker sheet and it was not what I was expecting. No racing stripes or the like. So I’m going to have the worst painted Cougar Classic ever! I say that because the only thing I do better than painting is so...