RC10Talk - The Net's Largest Vintage R/C Community

Lavigna wrote: ↑Wed Nov 30, 2022 2:52 pmI believe this is a TRX3 transmission, but the resident experts can correct me.

I'm no expert, but I believe the suspension parts are TRX-3, too.

Retro rc wrote: ↑Thu Dec 15, 2022 1:55 pm

GoMachV wrote: ↑Thu Dec 15, 2022 7:11 am Another solution
https://www.rc10talk.com/viewtopic.php?f=31&t=6297

Page 2 is exactly what I was meaning

91 Worlds,

Well done Thumbs.

Is "The Dom" an '89 car?. They weren't cheap !

Still waiting on parts for the build. Painted shell and wing first for a change.

Spent all day counting the holes in this shock tower.

Threw the body and wheels on the Mid 22 for a quick look.

Back in 92' when I started racing at Harewood RC Car Club in Christchurch, New Zealand, the most popular 2WD was the TRX-1. This car competed with Cougar 2 Works cars and a sprinkling of RC10's and Losi's. The two main model shops were Moore Models which sold the Traxxas buggy and Acorn Models which...

So, bad news on the rerere 6565. I was waiting for you to chime in with some compatibility issue...thanks :lol: I was unable to get my fan transmission to spin smooth, I ran it for 2 hours on my drill press and it was better but still not good. Frustrating for sure With the above news, I had anothe...

Back end's done. Quite a bit of fettling with the printed parts. The hinge pin holes were 3mm instead of 1/8" (3.18mm), so I had to ream those. The 5x11x4mm bearings wouldn't fit without some work. Traxxas rear arm mounts needed minor dremeling for outdrive clearance. Rear.jpg Best to use a goo...

Front clip done.

Mostly standard stuff. Some dremeling needed on the castor blocks.

R6cowboy wrote: ↑Tue Oct 15, 2024 8:14 pm Anyone know what size wheel the Schumacher "Full Spike" 1/10 Buggy Rear Tires fit, part # SCHT650?? Are these 2.2", or something else?

They are 2.0".

Orange and purple stuff. 8) Novak.jpg Novak ESC with cans. Not enough orange! ESC.jpg All this wiring for damn brushless? Motor.jpg Front width with the DT02 wheels is around 254mm. I have some BMAX2 wheels that take a 5x10mm bearing that I'll try. Rear width is 245mm with the Yokomo setup. Seeing o...

With the B-MAX2 front wheels, the front width is now 245mm, same as the rear. Just enough clearance from the Yokomo rod ends and arms throughout steering movement.

I'd say you'll be closer to a 33t pinion than a 23t. Remember those gearing recommendations in the manual are for 2.0" wheels, NiCd and 4-minute races. I believe the LRM trans is 2.18:1 ratio. 86/23 x 2.18 = 8.15 FDR 86/33 x 2.18 = 5.68 FDR Will a pinion that big fit?