RC10Talk - The Net's Largest Vintage R/C Community

scr8p wrote:there are no readily available rear bulkheads to replace a stock bulkhead. that's why i said ebay is your best bet. there's always used ones on there, and every now and then a new one.

Thanks for the information.

Is there an aftermarket threaded shock that you would recommend?

scr8p wrote:sp1

007.JPG

changebox

001.JPG

The one I have is identical to the SP1 picture.

Can you answer my other question about a replacement for the rear bulkhead if I use the two battery cup arrangement?

first thing..... which mip trans do you have? the 2.00 sp1 or the 2.61 changebox? that would dictate which trans i'd use in a 10t. How do you tell the difference? Also, if you want to use the two battery box holder arrangement, is there a replacement bulkhead minus the battery box that will work wi...

MIP USES the 6 gear mounting holes.If their not allready countersunk you may need to do so on your chassis.DON Is it worth swapping out a stealth for an MIP trans? There seems to be a premium for the MIP's and I personally don't know what the differences are in the two for the inexperienced racer l...

I have an MIP transmission that came off a RC10 graphite chassis. Will it fit the RC10T aluminum tub without modifications? I understand that the internals are the same as the stealth transmission, is this correct? Also looking for a new or used black RC10T rear bulkhead part #6323.

I have all the parts except those mentioned above. Do you know what the crossover part numbers would be? It has been 20 years since I have rebuilt one of these and I have a few that I want to rebuild. Not as easy as I remember.

Is there other associated truck tranny parts that will work/replace the #6585 clutch disk, #6584 outer hub and #6583 clutch hub for the stealth tranny? Anyone even have these replacement parts?

Group B wrote:

metallicats33 wrote:Besides the rear shock tower, all the GT parts should fit on a 10T

GT rear arm mounts don't work either

Then what manufacturer or other models parts will fit?

What would you recommend then?

Thanks for the replies. This really helps.

If I wanted to use all aluminum or carbon suspension parts front and rear, what manufacuturer would you recommend that would take the least amount of modifications?

Thanks for the information. Do you have any recommendations as to a moderate street type wheel and tire. I do have a couple of original sets of wheels and tires that have never been mounted that I don't really want to use. I currently have five trucks. Two are RTR's and three that need a little work...

What is a good reasonable set of wheels and tires that will work besides originals that will look good?

What aftermarket shock sets will fit or would need minimal modifications? What shock bushings will work also with stock arms?

Thanks for the information. I am bidding on two sets of shocks for the GT and the auction is almost over.