RC10Talk - The Net's Largest Vintage R/C Community

Got my body back from paint and it turned out pretty good. It's not perfect, but expectations of paying someone rather than doing it yourself are set a little higher. Overall I'm fairly happy with the job. In all honesty I'm not sure I could have done it better.

The more I look at the front bubble it looks like someone cut it off. I think losi made that piece to fit both the buggy and truck and it was interchangeable. I also think this might have been a first gen XXT and had some graphite upgraded parts added to it over time. Thanks everyone for the help.

Thanks for the reply. I've looked at that manual and that's what has me confused. All the XXT manuals show the "bubbles" with the battery brace, but some losi's came with the velcro battery straps and I can't find a manual to show that.

Here are a few more and I circled the "bubbles" in question. I say bubbles cause I don't know what you would call them.

I may have stumbled on a XXT-CR Graphite Plus. It's hard to tell from the pics but all the A-arms have graphite stamped on them. I can't see it on the front shock tower or the chassis brace, but the material and grain in the parts look consistent with some graphite parts I have when compared. The qu...

The holes do line up, but it doesn't sit inside the pivot plate flush. It's not as wide as the XXT ones.

I know this is an old thread but I had some pages I can add.

I emailed Trinity and they confirmed it was there's. I updated the post.

It was the GTX rear hub adapters

Thanks Lavigna! I'm probably going to pull of the shock collars, but we'll see how the finished product looks first.

More parts I forgot to take some pics of. I'm pretty lucky and really excited to have these. I'm still on the lookout for some more rare pieces.

Here is where we are currently. Lots of HG hop up parts and even used their GTX rear hubs. I'm not sure if I like the HG shock collars though... XXXT 3 degree pivot block and front titanium axles (Lunsford). You may notice the original steering in these pics. I was going to make this my runner, but ...

I had the MIP ball bearing steering setup that I never ended up using. I'm assuming because it didn't have a servo saver and would have killed my servo racing. I had to notch the frame to install it. It is much smoother that the original.

So this quarantine had me pull out the XXT and try to convert it to brushless. While scouring the internet for information I've run across this forum and after seeing awesome builds from Jamin, Lavigna and a couple other guys on here, it has made me rethink my actions. So this is my original XXT tha...

No brand markings anywhere. I wasn't planning on selling it. Just trying to find any info on it. Racers edge made them in purple and red, but I think they were the MK1 milled motor plates.

I had heard that this could be a Trinity purple motor plate for the XXT. I emailed Trinity and they confirmed it was. Pretty exciting as I have never seen one.