RC10Talk - The Net's Largest Vintage R/C Community

Yup either set of caps will be fine. The greens ones are a little light in value (102) is only 1000picofarads. Not sure about the others the values aren't present but judging by size they are within the right range. Thank you so much. I’ve been wanting to use that motor ever since I got it but I di...

brushed motors should as a general rule, use three 0.1uF-0.47uf caps, one from each brush to the can (or screw tab) and then one across the brushes. the value isn't super critical, whatever you can find that falls in that range. Some forward only ESC's recommend a schottky diode as well, it's up to...

When I was given this remote, I instantly knew that that was the remote I would use the most. When I tried it though, it never connected to the cars or made them go hay wire no matter what crystal I put in. I think it is the tx rf module because everything else on it works fine but i could be wrong....

I am using vintage radio gear so if I put any old capacitor on there it will be fine? I have some but I just didn’t know if there was a certain one I needed to put on it. Thanks for the response. I e been trying to figure that out for a while now.

Does anybody know if there are any resistors I must use on these motors if any?

Out of my three rc cars, this was the last and is the best. I put the biggest speed controller I had on it and giant off road wheels. I measured it to go about 30mph. By far my favorite custom rc car. It uses an Airtronics servo, a novak rooster speed controller, and a novak receiver. image.jpg imag...