On the Hunter, the paint killer did the job on the Gold... Almost I should say. It was painted from inside and outside for the Gold, and the part under the stickers are still there... I do question myself about removing the stickers or keep them...
Another Marui project - Ninja/Shogun
- silvertriple
- Approved Member
- Posts: 1646
- Joined: Sun May 02, 2021 10:31 am
- Location: France, Isere
- Has thanked: 591 times
- Been thanked: 840 times
- silvertriple
- Approved Member
- Posts: 1646
- Joined: Sun May 02, 2021 10:31 am
- Location: France, Isere
- Has thanked: 591 times
- Been thanked: 840 times
Re: Another Marui project - Ninja/Shogun
Bill Elliot sits now proudly on the Marui chassis
At this stage, this chassis has no electronics, the runner is not going to be this one...
I did add a few details to the bodyshell using some trim line applied inside the bodyshell...
I'm very happy with the result...
At this stage, this chassis has no electronics, the runner is not going to be this one...
I did add a few details to the bodyshell using some trim line applied inside the bodyshell...
I'm very happy with the result...
I buy kits to build and ru(i)n them
- silvertriple
- Approved Member
- Posts: 1646
- Joined: Sun May 02, 2021 10:31 am
- Location: France, Isere
- Has thanked: 591 times
- Been thanked: 840 times
Re: Another Marui project - Ninja/Shogun
I did put the Shogun driver figure and bodyshell on the chassis. I've not done any work on this chassis yet, it's not clean, but there is a very good basis for nice restoration (I have a plan for a Shogun runner beside this one: this one has been lightly ran, and is in pretty good shape, at the exception of one tire with a flat spot).
And I just noticed that I probably swap the wheels from right and left side which means there will be another set of pictures at some point
And I just noticed that I probably swap the wheels from right and left side which means there will be another set of pictures at some point
I buy kits to build and ru(i)n them
- silvertriple
- Approved Member
- Posts: 1646
- Joined: Sun May 02, 2021 10:31 am
- Location: France, Isere
- Has thanked: 591 times
- Been thanked: 840 times
Re: Another Marui project - Ninja/Shogun
Another body cleaned...
Red and white went out quite quickly. Black followed... After 24 hours of green bath I decided to remove it from the bath and take the gold out with paint killer. The body is a bit damaged at the front right, probably due to a collision. But that could still make it for a runner... I'll have to get organized to paint this bodyshell at some point, most likely with a simpler shema than the shelfer...
Red and white went out quite quickly. Black followed... After 24 hours of green bath I decided to remove it from the bath and take the gold out with paint killer. The body is a bit damaged at the front right, probably due to a collision. But that could still make it for a runner... I'll have to get organized to paint this bodyshell at some point, most likely with a simpler shema than the shelfer...
I buy kits to build and ru(i)n them
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 4 Replies
- 868 Views
-
Last post by RETRO R/C
-
- 3 Replies
- 1776 Views
-
Last post by purpletimbo
-
- 50 Replies
- 6497 Views
-
Last post by GeneralZod
-
- 14 Replies
- 3203 Views
-
Last post by Mr. ED
-
- 7 Replies
- 2006 Views
-
Last post by caesar
-
- 5 Replies
- 1407 Views
-
Last post by RedScampi
-
- 47 Replies
- 5951 Views
-
Last post by Frankentruck
-
- 244 Replies
- 6361 Views
-
Last post by silvertriple
Who is online
Users browsing this forum: No registered users and 1 guest