RC10Talk - The Net's Largest Vintage R/C Community

Here are the parts and options needed to build a Ten4 4WD RC10. Obviously a donor car is needed beyond what is listed here. For the Long wheelbase version, an un-cut noseplate is needed. Also note, you must use a 6565 rear transmission case (with...

I have released a front suspension kit for the RC28, SC28, MT28, RC28T, and other 1:28 scale cars and trucks. It's a direct bolt-on kit that replaces the lame living hinge front end on these cars with genuine suspension. The kit makes the cars...

The B1M bolt-in conversion kits are now available!

For the development of the kit please see here

Instructions for building the kit and parts list can be seen here

Here's a youtube video on the kit
imdCJylu8xA

Here's an earlier video...

Sorry, these are sold out

As you are all probably aware, new Stealth outdrives are no longer available for RC10's. It is not clear if and when AE will be offering them again. I've been working on printed steel outdrives , but a better option is...

I know a few of us are planning custom builds with composite chassis and different wheelbase options than what Brian and Jeff originally designed the kit for. After ordering the wrong belt, I found this online calculator that should help guys out in...

Lower Price!

Hey guys, going through my inventory, I found one and a half sets of my shorty battery cups and straps. I ordered another cup so now I have two complete sets for sale. If you're not familiar with these, you can check the thread here...

I will be offering custom nose tubes for the forthcoming Ten4 4WD RC10 conversion kit. The Ten4 kit is made to use the front noseplate in the long wheelbase position. That being the case, the factory RC10 nose tubes are too short. You can drill and...

Finally available! Now there is another option for mounting battery packs in the RC10, no drilling required!. These battery cups have the same look as the originals, but have an added boss on them that allows them to bolt in to the existing holes...

I'm putting the finishing touches on having the motor plates and rear towers for this conversion manufactured and would like to try and gauge the interest in buying the parts to do this conversion in a kit form. The thread detailing the parts is...

I have two of these in stock. $22 each + shipping. They come supplied with diff balls as shown. These are a direct replacement for the plastic RC10 DIFF gears.

20171210_173158-1008x756.jpg

I now have available battery straps for my transverse shorty pack battery cups, printed in Nylon.
I'll make these available at Shapeways in the next day or two, but for now I have 3 available for immediate shipment. The price is $8 plus shipping....

The Extended Shafts are no longer available. I am going to see if RR will manufacture more. If they will not, I will see about offering stock idlers that are pinned to extended shafts. I will keep this thread updated as I find out more

Part #...

After 9 months of R&D, countless hours of design, printing, testing, and too many prototype parts to count, the Ten4 4WD conversion kit components are finally available! For the full story on the development of the Ten4 see the thread here...

I have a number of products available for the RC10, that you can purchase from my Shapeways shop -->

Available right now I have:

RC10 0-degree rear arm mounts (3 deg of antisquat) $10.40

Used on sprint/oval cars where rear toe-in is not...