I got the esc and receiver in the mail today. These are in excellent condition. I might use the receiver in my Kinwald build and get a different receiver for this car.
Got hurt at work so my side work was held up which caused me to panic because I count on my side money to take care my family but I found out my foot wasn't fractured so I was able to pull this car off the chopping block. So any ways I have decided to change the body out for this Andy's b2 body and I got a new graphite front tower in the mail as well.
I really like the paint job. Hope your foot is better! Just took my kid to the doc last week for a foot injury... luckily his x-rays came back okay. Just a sprain....
To those guys that have sprained an ankle...I'll take a broken ankle over a sprained ankle any day so good luck with them and quick healing with low pain. Good luck.
Todd
Peace and professionlism.....Kabunga signing off!!!
OOOhh. I DO like that body. Is that body available from Andy's now that he is repopping his old stuff? Is there place to look at what he has besides FB... Would that shell fit on an RC10 with a CC chassis you think?
Im not sure if he is making more of them or not i just texted him and politely asked and he said he would do it. Im not sure how it would fit on a rc10 with that chassis.
i have wanted to do a build like this for a couple years now. thanks to al, jay, and paul for hooking me up with the nip stuff i needed to get it going. so here's the beginning of my t2 buggy, which i'm calling a B1.5. :)
Custom built rc10 t took months to build custom powder coat blue anodized arms hpi wheels edge tires up front losi smashers in rear universals metal gear steering servo losi hydra drive and custom painted body done all in house 20181124_210118.jpg...
Last post
The arms I got years ago and had sitting in my stock they were used but show absolutely no wear not sure what brand they are they look to be gpm units
So I'm in the middle of restoring an RC10 B3. It was only lightly run up to this point, but has a mix of parts from other cars. A lot of B2 parts, and shocks from a B4.
Compress_20230430_150032_2331.jpg...
Last post
Pretty much got this car wrapped up. It's all original team car stuff except the RPM front bumper, rear bumper, gear cover, and the Lunsford turnbuckles. Oh, and I opted for the factory team gold shock shafts. I took it out and ran it a bit, and...
Kind of surprised I didn't have a thread for this.
I got this truck a few years ago. Pretty solid. Even had Lunsford turnbuckles. But, no trans. Thankfully, i bought a b2/b3 lot shortly after getting the T3 and ended up with trans for it. I tore it...
Another one of my prized builds all chassis pieces are powder coated metal gear high torque servo hook esc and 10 turn brushless motor system jaco wheels and tires rpm arms and rear hubs rare hpi universals chassis skin is carbon fiber look...
This 10T was supposed to get a restoration, but inspired by the old/new builds in this thread my project has taken an unexpected turn. This will end up being a runner that I'll take to the track for the occasions when we have a turnout for 2wd....
Last post
Greg, use a losi cvd axel and rc10 cvd inner shaft, you can space the outer deeper into the
tranny outdrives, the B4 cvd axel will work as well
My preference is to get the car to legal buggy width and I figure I will need narrower arms to do this....