andy's trailing arm mounts

Post by **scr8p** » Tue May 29, 2007 12:41 am

do any of you guys that have this setup have mounts that are misdrilled? the only ones that i have that are corrcet are the ones marked 2L 2R for 2 degree rear toe. i can't remember exactly which ones, but either the ones marked 1L 3R, or 1R 3L, are actually drilled on the wrong side. it makes the mount hang off the right side on the chassis, and the left side sits flush with the edge. i didn't take notice to it on my c.c. andy's chassis, but on my real andy's chassis with the molded lip on the side, it showed up right away. i wasn't able to attach the mount to the chassis because the holes wouldn't line up. the mount hit the lip on the chassis. i'm guessing they'd all be like that, but i just wondered if anyone else found that same problem.

Post by **Asso_man!** » Tue May 29, 2007 4:14 am

I would be happy to see if mines have the same problem, but I'm moving in june and all my stuff is packed

Post by **scr8p** » Tue May 29, 2007 7:11 am

oh, its no big deal. the 2 degree mounts fit fine. i was just wondering if anyone else had notice the same thing.

good luck with the move.

Post by **Asso_man!** » Tue May 29, 2007 7:19 am

thanks Scr8p, I'm already exhausted with moving my RC10 stuff

Post by **Mr. ED** » Tue May 29, 2007 8:16 am

wher are you moving to?
Not too far from a good track I hope

Post by **Asso_man!** » Tue May 29, 2007 8:25 am

don't worry, I will be closer to my local track than before

and staying in Brussels (moving from downtown to Watermael-Boitsfort)...

Post by **Mr. ED** » Wed May 30, 2007 4:00 am

is traffic jam spelled in one word?

Post by **Asso_man!** » Wed May 30, 2007 4:11 am

yep, sorry Scr8p for polluting your original post

Post by **scr8p** » Wed May 30, 2007 6:07 pm

Asso_man! wrote:yep, sorry Scr8p for polluting your original post

no problem.

RC10Talk - The Net's Largest Vintage R/C Community