Help identify old Bolink pan car

[torchedcycle]

I have had this old roller for years, I'm cleaning it up to do something with it. Just need some info on what it is.

Thanks for any help.

[scr8p]

i'mm 99.9% sure it's a bolink. i'm not sure which model. they had the eliminator, invader, and i think another one. but i'm near positive it's a bolink.

[Eau Rouge]

Looks like a Bolink Eliminator set up for a Superspeedway quick-change battery system. Looks like the QC setup is missing, though.

[Kcal]

Cut down or narrowed Bolink?

[LowClassCC]

wow old bump..

body mounts are bolink.
shocks are bolink.
rear pod is bolink.

in the end i would have to agree with everyone else that its a bolink.

[Kcal]

Lol, sorry I am new and didn’t notice the date, at work, the field was wet, sun in my eyes, I really do apologize but perhaps I just made someone’s day that has been diligently checking their thread for the past 3 years eagerly awaiting a third response…… again sorry ill be more careful, I just picked one up off the bay and was researching what I could as Bolink doesn’t seem to be a super popular candidate for a restoration.

[dreambmx]

That's a modified Eliminator. The QC had a little different chassis. Also the front axle plate is a custom homemade looking jobby.

[reign79]

Your right about the front axel but it is not a qc it is a eliminator enduro they came with fiberglass battery trays you could swap out the qc used associated rc10 cups upsidedown and battery packs were replaced fron underneth.

[dreambmx]

You are correct sir! I just went and looked at my old Eliminator chassis. It has large cutouts on the side there just behind the front axle mounts. Good call.