RPM stealth conversion with b4 topshaft ?

[Caine]

I know people have said on here it can be done, namely pop the topshaft gear of so you can use the b4 slipper. But havent actually see anybody do it? Unless of course i've missed a post somewhere!
I'm going to do it on my 10T only way i can think of doing it is having a peice of steel bar drilled out to the right diameter then pushing it off using a g clamp or something similar.
Any other suggestions guys?

[Charlie don't surf]

I did one with a gear pulled, then tapped the new gear in place with a brass sleeve. But the newer b4 shafts with the black gears don't work so you would want an older shaft. What are you trying to do? You can run a b4 shaft in a 2.25 stealth w/o mods

[Caine]

I want to use the rpm gearbox casing. as you can still get them, and want my 10t to be as RPM'd up as possible!

[Charlie don't surf]

You can get the hydra shafts from RPM and then just use the 4 slipper assembly

[Caine]

Cheers

[Vermin]

I have a stock 3-gear Stealth trans and it was as easy as remove old top-shaft and install new top-shaft.

[Charlie don't surf]

He has the RPM 2.65 conversion that uses a smaller top shaft to achieve that ratio-

[slow_jun]

For RPM tranny Case, you will need this one.



bolts right in then use B4 Double Slipper and plates.

[Charlie don't surf]

Did you get that right from RPM? Last I knew they were in stock-

[Vermin]

He has the RPM 2.65 conversion that uses a smaller top shaft to achieve that ratio-

Yep, was just verifying 100% that it works with the stock 2.25 ratio stuff with no issue

[Charlie don't surf]

The top shaft will not work in a 2.25 case though-

[slow_jun]

Did you get that right from RPM? Last I knew they were in stock-

No, I got it from one of the members here, not sure who.. hahahaha... if im, not mistaken i got it from Aaron (aip47-2008).

Really? any links, still need to buy some spares. have the links?

[Soncho Ponza]

Awsome to know you can still get that top shaft...thanks

[aip47-2008]

I sent RPM a message concerning the top shaft in question, here is there reply:

Dear Mr. Aaron Evans,
I forwarded your note over to the owner of RPM. His response is as follows:

Yes, we can put one together for you. Send $15 in cash (only - please no personal checks) in a thick envelope with a note and your return address Attn: Richard

Please send your remittance to:

RPM R/C Products
c/o Richard Royall
14978 Sierra Bonita Ln.
Chino, CA 91710

Take care and thank you for your interest and support of RPM products. If you have any other questions or comments, please feel free to send us another e-mail.

[RichieRich]

Is it ok if I do the same?