Page 1 of 1
evader parts inter change
Posted: Sat Jan 10, 2009 12:52 am
by lowrydesign
has any one tried and modifying a rear pivot block chassis plate off the evader to fitt the xx series?
http://www3.towerhobbies.com/cgi-bin/WTI0095P?FVSEARCH=DTXC6978&search=Go
a lil cutting and drilling maybe??
Re: evader parts inter change
Posted: Sat Jan 10, 2009 4:53 am
by Mr. ED
backside looks ok, but maybe you better try to get some dimensions from duratrax.
Their contact details are in the same page on the tower site.
I had an eye on that part for another project, where did you find this 3d drawing of it?
Re: evader parts inter change
Posted: Sat Jan 10, 2009 12:36 pm
by lowrydesign
Re: evader parts inter change
Posted: Sun Jan 11, 2009 1:16 am
by wyldbill
i think the anodized evader pro rear plate would fit better and it has extra holesand arm mounts to play around with rear toe. here check it out
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXHWN3&P=7