Page 1 of 1

the best way to strip a body????

Posted: Sun Oct 12, 2008 8:35 am
by hugger19
i heard that nitro fuel was a good way to strip a clear body, but it leaves the body with a hase. is their a better way to strip the paint off a clear body????

Re: the best way to strip a body????

Posted: Sun Oct 12, 2008 9:34 am
by mrlexan
Buy a new one will hands down give you the best results. Seriously.

Re: the best way to strip a body????

Posted: Sun Oct 12, 2008 1:10 pm
by murphy3428
I have used this stripper for a couple years now (Citristrip gel) works much better than brake fluid and does not seem to harm the lexan, infact I have left it on over night and still no damage to the lexan. You can buy it at home depot or lowes. I usually leave it on for about an hour or so it can be a bit messy use soft terry cloth rag and a soft brissel paint brush to get into the crevises you also should tape up the exterior to limit scratching it. Hope this helps

Re: the best way to strip a body????

Posted: Sun Oct 12, 2008 3:55 pm
by fordtransman
mrlexan wrote:Buy a new one will hands down give you the best results. Seriously.


:D :D

Re: the best way to strip a body????

Posted: Wed Oct 15, 2008 3:36 pm
by Halgar
I usually start be unbuttoning her blouse ...

Oh, wait, that's probably not what you meant. :oops:

Re: the best way to strip a body????

Posted: Wed Oct 15, 2008 5:38 pm
by GJW
Halgar wrote:I usually start be unbuttoning her blouse ...

Oh, wait, that's probably not what you meant. :oops:
good talk :wink:

Re: the best way to strip a body????

Posted: Wed Oct 15, 2008 11:53 pm
by Halgar
marui hunter 73 wrote:
Halgar wrote:I usually start by unbuttoning her blouse ...

Oh, wait, that's probably not what you meant. :oops:
good talk :wink:
What do you mean "talk"?!? :? I'm just trying to help a bro out! :lol: :lol: :lol:

Re: the best way to strip a body????

Posted: Sat Oct 18, 2008 2:22 pm
by murphy3428
HPI has a nice mustang saleen body out there that would look nice until you find a new original body 20.00 on ebay

Re: the best way to strip a body????

Posted: Tue Nov 04, 2008 4:28 am
by FasterLouder
Gary's an Austrailian-'nuff said! (I'm a Kiwi-I'm allowed to rib Aussies!)

I scored a JRX Pro in a trade a few weeks ago.
The OG paint was there,on the inside,but there were three coats of paint on the outside,hiding it.
I used acetone on a Q-Tip...Rub-A-Dub-Dub.
Didn't make the lexan cloudy,either,worked a charm.
I had a couple of vintage Orion decals that had got wet in the packet and some of the print from the instructions had transferred onto them.Acetone on a Q-Tip to the rescue,again!
Perfection.

Re: the best way to strip a body????

Posted: Wed Nov 05, 2008 4:56 pm
by MOmo
Buddy used some DOT Brake fluid. It wasn't over a whole body, just a part of one, but said he didn't notice any fogging and or damage to the lexan.

Not sure is anyones tried it.




MOmo

Re: the best way to strip a body????

Posted: Fri Nov 07, 2008 8:25 pm
by GJW
Halgar wrote:
marui hunter 73 wrote:
Halgar wrote:I usually start by unbuttoning her blouse ...

Oh, wait, that's probably not what you meant. :oops:
good talk :wink:
What do you mean "talk"?!? :? I'm just trying to help a bro out! :lol: :lol: :lol:
i mean im with you on that subject, i like the way your mind works...

aussie lingo is different thats for sure + my mates are all surfers which doesnt help..we have new sayings all the time :roll:

Re: the best way to strip a body????

Posted: Sat Nov 08, 2008 2:44 am
by Halgar
marui hunter 73 wrote:
i mean im with you on that subject, i like the way your mind works...

aussie lingo is different thats for sure + my mates are all surfers which doesnt help..we have new sayings all the time :roll:

No worries. 8)