RC10Talk - The Net's Largest Vintage R/C Community

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=140223645097&ssPageName=STRK:MEWN:IT&ih=004

+

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=300182474083&ssPageName=STRK:MEWN:IT&ih=020

+

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=350045419183&ssPageName=STRK:MEWN:IT&ih=022

+

http://www.rdent.com/sprint/sprintrcb3gbx.html

= ANOTHER MONEY PIT

We have a new clay dirt oval and I am going to try my hand at it. I have a GTB with a 10.5 and Orion 3200 Lipo coming out of my B4 that will find a home in this dude. I may have paid a little much for the B3, but oh well. I believe the Losi street weapon shocks will work well with this chassis. I have all the other hardware for the shocks to complete them besides springs. I have always liked the 1/10 sprint car look.....

you'll find those shocks very hard to set up for DO, never can seem to get the right piston/spring ratio--also that r&d car is has a VERY high center of gravity so if it gives you
a tough time, don't feel bad it's not uncommon with that car. If your in Tennesee you can
always hop over to Cherryville NC to C&S raceway--we ran the US Openwheel Champs there
not too far------


Reggie

I'm just going to run my gt on the DO until I can get a nitro late model setup. 4wd gas! and mucho downforce! that's what we used to run in tucson, and if the track is smooth it's actually fun, if the track is not smooth i just put a little more suspension travel into the car, it made drifting all the way around the track pretty fun!

Mark
PS see you up at white house for the next points race hopefully Brandon

I figured that it would be a little high in the CG category. Not really looking to get too hard core into it, just want to go out and have some fun. (of course I say that now)

A Main still carries all the springs available for the street weapon, I plan on getting quite a few sets for tuning options.

I'll be there Mark!