Also, look in the General Forum at some of the topic's posted in the past. There are at least 2 that I know of that address the parts needed to upgrade to B2/B3 rims and axles.
My old to new build has hit a snag. Ordered a low profile servo from hobby king. It fits but it glitches and makes a lot of gear noise. So I ordered a hitek 77mg low profile. Its nice but its too long. 1.73 instead of a 1.6 Now all I care about is...
Last post
Here are 2 low profile options, while I havent hit a track with my car yet, out front on the asphalt I have no problems whipping the car around.
metal gear
they have a non metal gear version also for under 20, but i dont see an auction for it...
Looking for a gearing suggestion for reviving my basher 10T with Stealth trans. I'm running a 2s Lipo through an older Novak Rooster ESC to either a 15t or 17t brushed motor. Just going to be bashing in some empty mixed surface lots maybe an...
Last post
Thanks for the help guys. Yes I was planning on doing the B4 slipper. I do have the stock 87t spur on the truck now.
So I just purchased my first DC only NiCD and NiMH peak charger but now I need to get a power supply for it. Can anyone suggest a good one? I really don't want to spend a lot of $$$ on it because my wife already has her sniper rifle sighted in my my...
Last post
Thanks for the suggestions wyldbill... I appreciate it. Maybe I'll take a ride to Radio Shack tomorrow and see what they have in stock.
As the title states, I am looking for a starting point for a 14T double. I'm running an 81T spur and the car will be run a very tight track with one long straight.
Thanks.
Last post
With 81 tooth spur start with 13 or 14 tooth pinion and run for 3 minutes and check temps,if around 55 -60 degrees Celsius go smaller if under 50 degrees Celsius let cool and run full five minutes and check final temps again.. :mrgreen:
Running a 54T 32P AE spur. The B4 RTR manual recommends 9.57 as FDR for a 19T motor (I think the original Radon 17T was stock in that car). A 54/10 would be in that neighborhood for the six gear, does that sound about right? I'll most likely run...
Last post
You buy lipo stick packs, same dimensions as nimh. They even fit older Tamiya cars.
I would like to suggest that we have a sub-forum where those of us content creators can post links to our social media pages. Most of us here enjoy sitting back to a few YouTube videos, Instagram TV or what not. With this sub-forum, we can easily...
Last post
Isn't there a facebook version of RC10Talk kinda thing already? Could these types of things be done thru that porthole ? I think some of the rustic appeal of RC10Talk proper comes from it being an old fashioned forum that is essentially completely...
I have just had the brainstorm of 3D printing a radio wheel. I printed a radio wheel for my traxxas transmitter yesterday and thought to myself. What if I printed a wheel that looked just like an original rc10 wheel?!? Well in about 3 hrs I...
Last post
I could, but that would take a while to get the letters right. Any other wheel ideas? Kyosho, Traxxas, Losi, Real wheels?