inverted servo mount

General discussion, builds/restorations, etc...

Moderators: scr8p, klavy69

rdnether
Approved Member
Posts: 32
Joined: Wed Jan 04, 2012 9:34 am
Has thanked: 4 times
Been thanked: 4 times

inverted servo mount

Post by rdnether »

In order to get my steering linkage to line up well, I tried something new and inverted the servo
114285.jpeg
The obvious drawbacks are 1: higher center of gravity 2: servo is more vulnerable.
Any other thoughts?
Top
User avatar
juicedcoupe
Super Member
Posts: 3574
Joined: Sun Aug 16, 2020 4:05 pm
Location: Pascagoula, MS
Has thanked: 273 times
Been thanked: 2113 times

Re: inverted servo mount

Post by juicedcoupe »

Does the linkage clear through the full range of travel? If so, run it.

Several cars have the servo mounted like that.
Always looking for new and interesting ways to waste money.
Top
1911Colt
Approved Member
Posts: 1299
Joined: Fri May 06, 2022 9:11 am
Has thanked: 1792 times
Been thanked: 868 times

Re: inverted servo mount

Post by 1911Colt »

It doesn't contact the body? It seems that it would.
Top
rdnether
Approved Member
Posts: 32
Joined: Wed Jan 04, 2012 9:34 am
Has thanked: 4 times
Been thanked: 4 times

Re: inverted servo mount

Post by rdnether »

juicedcoupe wrote: ↑Mon Jun 23, 2025 10:16 pm Does the linkage clear through the full range of travel? If so, run it.

Several cars have the servo mounted like that.
Thanks for the reply, linkage is clear.
Top
rdnether
Approved Member
Posts: 32
Joined: Wed Jan 04, 2012 9:34 am
Has thanked: 4 times
Been thanked: 4 times

Re: inverted servo mount

Post by rdnether »

1911Colt wrote: ↑Tue Jun 24, 2025 7:40 am It doesn't contact the body? It seems that it would.
I am using the original RC10T body, and it doesn't contact. Surprisingly, it's not even close.

Thanks!
Top
Chewbacca
Approved Member
Posts: 630
Joined: Sat Jun 24, 2006 6:41 am
Location: Herrenberg, Germany
Has thanked: 51 times
Been thanked: 114 times

Re: inverted servo mount

Post by Chewbacca »

If that is a truck - no problem. For a buggy you can swap to a low profile servo. Then the linkage lines up nicely in a normal flat position.
*** POWDER - KING ***
Top

Create an account or sign in to join the discussion

You need to be a member in order to post a reply

Create an account

Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute

Register

Sign in

  • Similar Topics
    Replies
    Views
    Last post

Return to “RC10 Truck Forum”

Who is online

Users browsing this forum: No User AvatarAmazon [Bot] and 4 guests