2.2" wheels for TRX-1 & TRX-3

[srobert910]

what wheel options have you found that work for a TRX-1 and TRX-3? Do the Traxxas 2474 Bandit wheels work? They look like they would. How about fronts? anyone make a wheel that fits a 10mm bearing that has the right offset?

[juicedcoupe]

Probably these, although you should confirm with them.

https://www.jcracingproducts.co.uk/wheels/traxxas-1/traxxas

Even though they are in the UK, my orders have always arrived surprisingly quick.


Just note that the fronts are the narrow design. You will need matching tiles. Schumacher and Pro-line have a few. JC Racing also has some of their own. I have also used vintage 2.15" tires on them.

Just didn't confuse JC Racing with JConcepts. I see it happen often.

[TRX-1-3]

Probably these, although you should confirm with them.

https://www.jcracingproducts.co.uk/wheels/traxxas-1/traxxas

Even though they are in the UK, my orders have always arrived surprisingly quick.


Just note that the fronts are the narrow design. You will need matching tiles. Schumacher and Pro-line have a few. JC Racing also has some of their own. I have also used vintage 2.15" tires on them.

Just didn't confuse JC Racing with JConcepts. I see it happen often.

Can confirm JC Racing wheels for vintage Traxxas do fit.
Or you could find some TRA2672 rears 2.2 for TPC/TRX-3. I've ran hexes on the rear before (I believe they were Schmacher pre mounted), never the Bandit wheels though. You could just order a pair of Bandit hex rears and see if they fit, then convert the front to hex using Bandit knuckles and carriers and run the Bandit fronts too. Or if you can find a set of original Bandit wheels, pin drive rears and bearings in wheel front. I guess the mini e Revo wheels are hex and sized at 1/10th 2.2 buggy. Those for the rear? Not sure about the offset though.