RC10Talk - The Net's Largest Vintage R/C Community

Hi all,

Just got myself another project. A very nice Junior T.
However it is missing a body and the rear body mount.
Since I recently got myself a (cheap) 3D printer I´d like to try to print a rear body mount to use until I get a hold of a genuine one.

Now I need your help. I need someone with a Junior T or a JrxT to take some measurement for me.
I´ve made a quick sketch:

I have the most measurements figured out already but I need help to find "A", "B", "C" and "T".

Thanks!

A = 3.250”
B = 5.938”
C = .512”
T = .125”

That was quick!!!
Thanks BattleTrak!

Proof of concept seems ok:
Forgot to put a big radius on the actual tabs that go through the body, but otherwise ok.

The printer had blue filament in it so that´s why the Clod rere blue!