RC10Talk - The Net's Largest Vintage R/C Community

I like alot of you here have been looking for dogbones or cvds. Only to find no one makes anything. I set to find something that will work. I found hpi 113713 fit with my setup though they are a little longer than id like. Rc10nds with sc10 rear uprights.


I also made my own cvds as well with associated and hpi parts.again but they maybe little short for my setup. may fit better for the stock ds upright. Haven't tried that out yet. Here is a a pic of said concoction

Did your Associated/HPI setup work??

It will work for a shelf car. Not f as r a car that's used alot. The cross pins are slightly smaller than original.