RC10Talk - The Net's Largest Vintage R/C Community

Hey gang -- need some help finishing a JRXT shelfer I'm working on. I bought a body off ebay, but somehow it did not include any of the markings for the body mounts. Would someone with a JRXT be willing to take some measurements so I know where to punch the holes?

Thanks!

Top_Billing wrote: ↑Wed Apr 11, 2018 6:05 pm Hey gang -- need some help finishing a JRXT shelfer I'm working on. I bought a body off ebay, but somehow it did not include any of the markings for the body mounts. Would someone with a JRXT be willing to take some measurements so I know where to punch the holes?

Thanks!

Hi there

if it's from TBG you bought it, it will have slightly different dimensions from the original due to the re-molding process. measurements that we could provide you might not end up at the right place. Your best bet is to cut it fully, THEN position it on the body and mark where the holes should be done... I think!

Best,
Paul

Was afraid of that. Thanks.

Hello!

I just found out that have some new bodys for different vintage Losi models, Will post some pictures.

Peter

You may have even gotten the body from me. Our MRLEXAN mold doesn't have the marks for body mounts. I do have an original body here and the marks are so faint it probably wasn't picked up real well when they made the reproduction mold.

Just don't mount it too far forward. I see too many with the body so far forward, it looks like a truck version of the Dodge Intrepid with the cab forward design.

Here's some photos of my Bluegroove body on my JRXT, hope it helps!

oooh that's lovely!