RC10Talk - The Net's Largest Vintage R/C Community

Im looking for someone to cut out some side frames for a helicopter project Im building. The parts are appx 8"x10" and are a G10 and wood laminate that I will provide. I can also provide a stock frame I have for reference but there are a few changes Id like made. It would be best if you could draw the parts up in your preferred software but I might be able to draw them and send the file. Id really rather you did that tho.

I have the laminate glued up and ready to cut. Im looking to get this done soon. Im more than willing to pay for this service. If anyone can help me please PM me and I will provide more details.

Thanks, Mike

Might try Jake (seabass) or Derrick (Durb69) but neither come around here a lot. Both are Facebook old school a lot

Mike I can do the drawing and cutting for you. Email me at jacob.emperley2yahoo.com

Will do! I wanted to ask you directly but didnt know if you were still doing work.

Thanks Jake. I will email you tonight or tomorrow.

email sent!