RC10Talk - The Net's Largest Vintage R/C Community

I thought about putting this in the re-re section because all the plastics are new, but the TPS and bottom-loaders with notched-pistons made me keep it here.

I'm planning to run this next season at my local dirt oval, and possibly the rest of this season if I can finish it. I still have to buy modern electronics and will be sending the body out for custom paint since I suck at it.

- TPS chain-drive tranny
- McAllister lowering kit
- MIP 3/16" CVD's (Thanks Jeff Malar!)
- Tecna 6-40 tie-rods with RPM cups
- Andy's bumper/body mounts
- CW Bullet Wedge

That is very clean looking; very well done. Please post pictures of it finished.

Hi Dave,

Looks too nice to run!

Cheers, Dave.

Well that looks familiar!

Nice score LTO! That was my first choice but NCOHOG has another on my wish list...

I can't believe you didn't pick up a Bat Wedge!!!

knucklebuster wrote:I can't believe you didn't pick up a Bat Wedge!!!

I have an NIP Premier Designs Bat Wedge that's for another project. I thought about picking up a TBG repop, but I try not to support him and use original bodies.

I have a CW Bloomquist Wedge that I'll probably spray bomb and use for practice laps.

I already have the paint design sketched and a painter on the East Coast willing to do the airbrushing. I won't post any pics until I have the Bullet mounted on the car just to keep everyone in suspense.

Yet another beauty!

Looks killer! Look forward to seeing the body.