Parts Bin Oval AKA How improperly can we build an RC10?
Posted: Tue Jan 13, 2015 8:51 pm
I hope this is the right place for this, though I intended it to be more of a dirt oval car, rather than carpet oval.
Basically made out of parts I had laying around, built on a graphite Houghes chassis, cause that's what I had.
![Image](http://i.imgur.com/Xipj700.jpg)
![Image](http://i.imgur.com/lhSPQ1X.jpg)
![Image](http://i.imgur.com/sBA2TdB.jpg)
![Image](http://i.imgur.com/0gu1wmy.jpg)
![Image](http://i.imgur.com/r2WvU02.jpg)
A work in progress...
I designed some front shock mounts to be 3d printed, and I need to design and print a front shock tower to lay the shocks down like a mccallister lowering kit.
The rear shock tower is a stock shock tower that I chopped the bottom off and drilled some new holes in.
Enjoy
Basically made out of parts I had laying around, built on a graphite Houghes chassis, cause that's what I had.
![Image](http://i.imgur.com/Xipj700.jpg)
![Image](http://i.imgur.com/lhSPQ1X.jpg)
![Image](http://i.imgur.com/sBA2TdB.jpg)
![Image](http://i.imgur.com/0gu1wmy.jpg)
![Image](http://i.imgur.com/r2WvU02.jpg)
A work in progress...
I designed some front shock mounts to be 3d printed, and I need to design and print a front shock tower to lay the shocks down like a mccallister lowering kit.
The rear shock tower is a stock shock tower that I chopped the bottom off and drilled some new holes in.
Enjoy