Page 1 of 1
please help me with car/body identity
Posted: Sun Sep 14, 2014 3:16 pm
by crazy nick
I have this modified body from the '80s. I am trying to figure out what car it was drilled for. The rear 2 holes are 1 7/8" center and from front hole to rear is 10 1/4. I know its a long shot but i d like to build a car to put this body on ie frog, hornet, grasshopper ect....
Re: please help me with car/body identity
Posted: Sun Sep 14, 2014 3:26 pm
by Phin
Parma Mud Bus
Looks like it was mounted on an RC10 and the wing tubes were used as the rear body mounts.
Re: please help me with car/body identity
Posted: Sun Sep 14, 2014 3:37 pm
by crazy nick
Phin wrote:Parma Mud Bus
Looks like it was mounted on an RC10 and the wing tubes were used as the rear boy mounts.
Oh ya i didn't even think of that. Thank you Phin!
Re: please help me with car/body identity
Posted: Mon Sep 15, 2014 3:35 am
by EvolutionRevolution
crazy nick wrote:Phin wrote:Parma Mud Bus
Looks like it was mounted on an RC10 and the wing tubes were used as the rear boy mounts.
Oh ya i didn't even think of that. Thank you Phin!
You guys mount boys on your chassis?
TMI alert.
And where there is a rear boy, there is a front boy....do they face each other or not?
Re: please help me with car/body identity
Posted: Mon Sep 15, 2014 9:03 pm
by klavy69
if the rc10 idea doesn't pan out you can always do a custom body mount setup to make holes meet the marks. Would be a cool body to run/display...
Todd
Re: please help me with car/body identity
Posted: Tue Sep 16, 2014 7:33 am
by crazy nick
klavy69 wrote:if the rc10 idea doesn't pan out you can always do a custom body mount setup to make holes meet the marks. Would be a cool body to run/display...
Todd
Ya I agree will be very cool. Its in great shape and not a bad paint job at all.
Re: please help me with car/body identity
Posted: Tue Sep 16, 2014 7:42 am
by Phin
I'm guessing the body was mounted like a giant wing...with wire and wing buttons.