RC10Talk - The Net's Largest Vintage R/C Community

there was a nip fusion speed tub on ebay a couple months back. i think it sold for $450, or somewhere around there.

Anyone from this forum pick that nip one up???

I believe badhoopy has a couple, though not from this auction. Review his collection and posts you won't be dissapointed.

I have a hardly used one that needs a resto. I think you might be waiting a long time with that on your list. Even Santa will have a hard time finding that one.

wow less than $100, i dont think that can be made anymore for less than $100 in supplies lol..

I have a badly beaten one.

it says its guaranteed against breakage, i say you contact horizon hobbies and demand a replacement or refund lol

Scr8p worked some magic on it and it looks good its just not new, If I thought i could get a new chassis out of Horizon I would send it back in a hart beat !! LOL

noony wrote:Scr8p worked some magic on it and it looks good its just not new, If I thought i could get a new chassis out of Horizon I would send it back in a hart beat !! LOL

You might contact them, maybe they held a few back for "warranty claims"...

get one from fibrelyte for $150 http://www.fibre-lyte.co.uk/

I know, I know, it's not a fusion...... But it's still available.....

bngiles wrote:get one from fibrelyte for $150 http://www.fibre-lyte.co.uk/

I know, I know, it's not a fusion...... But it's still available.....

If you can get them to make you one you will have done better than a number of other members. I live quite close and have called in to see them on a number of occasions but seem unable to convince them to re produce these chassis, even if they did they are now talking in excess of $200 before shipping and no nose plates .

FERRETTI wrote:

bngiles wrote:get one from fibrelyte for $150 http://www.fibre-lyte.co.uk/

I know, I know, it's not a fusion...... But it's still available.....

If you can get them to make you one you will have done better than a number of other members. I live quite close and have called in to see them on a number of occasions but seem unable to convince them to re produce these chassis, even if they did they are now talking in excess of $200 before shipping and no nose plates .

Didn't someone else make one or have one made by them? Wasn't it atomic_carbon or someone? (I forget their name properly)...

Atomic-Carbon and Fibre-Lyte are the same company. They once thought about making those chassies again but the nose plate was too hefty to produce...

Here is mine, still NIP

http://www.rc10talk.com/viewtopic.php?f=4&t=614&start=0

Asso_man! wrote:Atomic-Carbon and Fibre-Lyte are the same company. They once thought about making those chassies again but the nose plate was too hefty to produce...

Here is mine, still NIP

http://www.rc10talk.com/viewtopic.php?f=4&t=614&start=0

Hi Asso_man

Is that chassis from Fibrelyte or ComCom ?
Because ComCom was a german company that made Tub chassis for almost all makes at the time.