Page 1 of 1
Hello from Australia
Posted: Wed Jun 04, 2014 2:26 am
by Wazza22
G'day everyone!
I'm a long time RC fan (28 years to date!) and have recently acquired a SG Coyote. This was the car I had always wanted when I started racing off road almost 3 decades ago!
I will upload some photos once I get some of it sorted.
Cheers,
Wazza22
Re: Hello from Australia
Posted: Wed Jun 04, 2014 1:03 pm
by 1300GT
G'day Wazza. Welcome to the site.
Looking forward to seeing the Coyote pictures. Is it 2wd or 4wd?
I picked up two 2wd Coyotes recently to make a 4wd. I'll post details and pictures up eventually.
Re: Hello from Australia
Posted: Thu Jun 05, 2014 2:31 am
by Wazza22
Hi Chris,
Its a 2WD, I would love a 4WD but I have been unable to source a front gearbox housing, centre drive shaft etc.
Ill have some photos up soon.
Cheers
Re: Hello from Australia
Posted: Thu Jun 05, 2014 2:40 am
by GoMachV
I just sent my rwd Coyote off to OZ a few months back! I still have a nib 4wd (it started as a fwd version and I added the parts from a rwd to complete it). Cool cars, but some major flaws like the gears, shocks, and shock mounts.
I donated the original body to TBG for them to make the mold. They are using my pic in their listing
Re: Hello from Australia
Posted: Thu Jun 05, 2014 8:33 am
by bearrickster
gomachv wrote:I just sent my rwd Coyote off to OZ a few months back! I still have a nib 4wd (it started as a fwd version and I added the parts from a rwd to complete it). Cool cars, but some major flaws like the gears, shocks, and shock mounts.
I donated the original body to TBG for them to make the mold. They are using my pic in their listing
not a fan of these cars (just because I no nothing about them) But yours looks Fantastic!!! I love the paint combo
Re: Hello from Australia
Posted: Thu Jun 05, 2014 10:13 am
by ChisaiKuso
Welcome to the forum, Wazza22.
Re: Hello from Australia
Posted: Fri Jun 06, 2014 4:43 am
by Wazza22
Thank you all for the warm welcome!
I intend to run my example and thankfully it has all steel gears. I am also looking at fabricating some small shock towers and running associated shocks.
Can anyone point me in the right direction around which late model wheels would fit?
Cheers
Re: Hello from Australia
Posted: Fri Jun 27, 2014 12:58 pm
by SONYtec
Welcome!!!
Cool!!!